Re: WR18 forming bulkhead

Posted by mike noeske on May 13, 2004

Before I put the the two small bulkheads in I sanded the point off the very bottom with a belt sander, so that water could drain thru. I also drew lines about a inch from the inside opening on the sides and about 3/8 of a inch on the top, following the outside shape. When I get back to working on my WR18, after the interior and exterior of the hull is glassed, I plan on cutting around the lines with a coping saw, thus removing the majority of the bulkhead. The ramaining bulkhead will be about 1/2 inch at the hull and 1 inch at the deck. Mike

In Response to: WR18 forming bulkheads by Dennis Rioux on May 13, 2004

Replies:

No Replies.