Re: Copper sutures

Posted by Chequerboard on Feb 4, 2005

Great stuff - thanks everyone.

My concern was much as Ken said above - the desire to keep the fillets small, light and clean.

However, the hull is fair with the wires and I'm not keen on the possibility of upsetting that by progressively replacing wires with tabs.

I'll try a 3/4" fillet over the wires somewhere out of sight and see what kind of results I get.

Cheers.

In Response to: Re: Copper sutures by terry on Feb 4, 2005

Replies:

• Re: Copper sutures by terry on Feb 4, 2005
  • Re: Copper sutures by Laszlo on Feb 4, 2005
    • Re: Tabbing by Dave Houser on Feb 4, 2005
      • Reasonable result... by Chequerboard on Feb 5, 2005
        • Re: Reasonable result... by CLC on Feb 5, 2005
        • Looks fantastic! by Ken Leffert on Feb 6, 2005
        • Re: Reasonable result... by Mac on Feb 6, 2005
          • Arr, well done, Laddie! by Robert N Pruden on Feb 7, 2005
        • perfect by LeeG on Feb 7, 2005
    • I'm with Laz on this issu by Robert N Pruden on Feb 7, 2005
• Re: Copper sutures-gaps by Gayle Rhodes on Feb 7, 2005
  • Re: Copper sutures-gaps by Chequerboard on Feb 7, 2005
  • Re: Copper sutures-gaps by Chequerboard on Feb 7, 2005
    • Re: Copper sutures-gaps by Gayle Rhodes on Feb 7, 2005
      • Re: Copper sutures-gaps by Chequerboard on Feb 7, 2005
        • Re: Copper sutures-gaps by allanreade@paradise .net. on Feb 8, 2005
          • Re: Copper sutures-gaps by Gary Turner on Feb 8, 2005
  • Ok, I'll keep reading by Robert N Pruden on Feb 9, 2005
    • Addendum by Robert N Pruden on Feb 9, 2005