Builders' Forum Archives |
Re: Ch 17 LT Bulkheads
Posted by Bill Brennan on Aug 20, 2005
Thanks evrybody. In the end I was able to place the aft bulkhead in is proper place and wire it in. With a little bit of pullimg the sides in towards the stern and then putting the spreader stick back in place I was able to get the beam to 23 1/4". There are no flat spots in the keel and the hull is fair. On to the fillets.
I am a first time builder and appeciate the advice you all give. You guys are great!
Bill B.
In Response to: Re: Ch 17 LT Bulkheads by CLC on Aug 19, 2005
Replies:
No Replies.