Builders' Forum Archives |
Re: S&G Wire Cutter
Posted by Mark Camp on Jan 30, 2006
Good idea. Maybe reshape the cutting edge of a wire cutter so that it is curved rather than flat. To use it, cut the wire once. The wire is now rounded when viewed from one angle; it is actually cylindric. Twist it 90 degrees and cut again. Now it is a faceted approximation of a round end. Close enough to allow easy insertion.
In Response to: S&G Wire Cutter by Mac on Jan 30, 2006
Replies:
- Re: S&G Wire Cutter by Mac on Jan 30, 2006
-
Re: S&G Wire Cutter by Mark Camp on Jan 30, 2006
- How 'Bout This? by Mac on Jan 30, 2006
-
Re: S&G Wire Cutter by Mark Camp on Jan 30, 2006