|
» Launched! Mill Creek 16.5
|
| AndrewLB on Wed, November 2 2022 » 9:09 AM, 2 Replies |
|
» Rigging slat seats in the Mill Creek 16.5
|
| AndrewLB on Mon, September 26 2022 » 1:21 PM, 1 Replies |
|
» Clean up after sanding between varnish coats
|
| AndrewLB on Thu, September 15 2022 » 1:45 PM, 16 Replies |
|
» Flush hatches: mixed success
|
| AndrewLB on Sat, October 16 2021 » 2:52 PM, 3 Replies |
|
» Precipitate in epoxy hardener
|
| AndrewLB on Sat, October 16 2021 » 2:34 PM, 1 Replies |
|
» Hatch anxiety
|
| AndrewLB on Sun, October 3 2021 » 7:36 AM, 9 Replies |
|
» Rice paper/ graphics
|
| AndrewLB on Wed, August 11 2021 » 5:43 PM, 8 Replies |
|
» Epoxy cure before paint
|
| AndrewLB on Sun, August 1 2021 » 10:46 AM, 6 Replies |
|
» Mill Creek 16.5: Any tips on traditional slatted seats?
|
| AndrewLB on Sat, July 24 2021 » 11:01 AM, 5 Replies |
|
» Bulkhead proud of shear panel: fitting foredeck
|
| AndrewLB on Tue, June 8 2021 » 6:59 AM, 2 Replies |
|
» End pour for rudder; mounting
|
| AndrewLB on Tue, June 8 2021 » 6:42 AM, 2 Replies |
|
» Final dust wipe before epoxy?
|
| AndrewLB on Thu, May 20 2021 » 10:09 PM, 7 Replies |
|
» Filleting at flat joints; removing wires
|
| AndrewLB on Fri, April 23 2021 » 11:54 AM, 1 Replies |
|
» Planing sheer clamps: Radius guides for Mill Creek 16.5
|
| AndrewLB on Tue, April 20 2021 » 9:49 PM, 1 Replies |
|
» Epoxy pump between uses
|
| AndrewLB on Sun, April 11 2021 » 3:54 AM, 8 Replies |
|
» Just out of the box... puzzle joints and nubs
|
| AndrewLB on Mon, April 5 2021 » 10:04 PM, 18 Replies |
RSS
